Peugeot 308 Key Fob Replacement

Peugeot's 308 is a bit old but it's still eye-catching. It's not the most luxurious vehicle in its class, but it is a pleasant and peaceful drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is intermittent or constant the following tips will aid.

Water Damage

If you accidentally drop your key fob into a puddle, or if it is wet while kayaking, canoeing, rafting or canyoning, the fob is likely to be damaged by water. The best way to prevent this from happening is to always keep it in a dry container when you're outdoors or performing activities in which the fob may be exposed to a lot of water.

It's also important to make sure that the fob is completely dried before you open it and use it again. If you detect any odors emanating from the fob (such as industrial liquid or windshield washer fluid) it is a indication that it's submerged.

A circuit board that's wet can cause the battery to discharge its energy or even explode. If you are able to get the 308 keyfob from the water, turn the button side up and shake as much water as possible before opening the casing. After you open it, remove the battery and wipe the circuit board using an alcohol-soaked cotton swab. 90 percent isopropyl alcohol.

Other reasons your peugeot 208 keys 308 remote keyless entry system may not function include a dead coin battery or receiver module issue signal interference, a faulty electronic chip. If none of these causes the problem, you can try resetting your system by disconnecting the 12 volt battery for around 15 minutes.

Dead Coin Battery

peugeot 208 spare key cars come with remote start technology which allows drivers to start their vehicle from some distance, which allows them to warm up or cool down the car before entering. This feature is very useful, especially in the cold winter months. Remote start systems may be stopped for a variety of reasons, including an inactive coin-battery.

A coin-shaped battery that is in the key fob has a lifespan of between two and four years, based on how often used and the location where it was purchased. The date of use will be displayed on the packaging or marked in the user's manual.

If the key fob has stopped working after exposure to clean tap water it is recommended to remove the battery, clean the chip with a paper towel and isopropyl ethanol, then dry it completely before replacing it. If the key fob was exposed to salty or soapy water, it may have caused the chip to be damaged. It is recommended to replace it.

If you're unsure whether the battery is defective, you can check its voltage with an instrument connected to the terminals plus and minus. If the voltage is less than 12-13 volts then it is time to replace the battery. Alternatively, you can try to reset your on-board computer by disconnecting the battery with 12 volts for a couple of minutes, and reconnecting it in reverse order (positive cable first, then negative). The engine should begin to run after this.

Faulty Receiver Module

If you're not receiving the "Key Detected" message on your dashboard, then it's possible that your receiver module has developed a fault. It's that part that sends an indication to the car when the key fob is activated, it also acts as an immobiliser, and stops it from starting until the key that you want to use is present.

This could be due to a variety of reasons, including water damage or simply getting old. If the electronic chip within your Peugeot 308 keyfob has been damaged by dirty tap water it could be due to the fact that the keyfob was contaminated with it. In this situation, you'll have to take it off and clean it thoroughly using isopropyl or an electronic cleaner. Once the battery has dried, you can try again.

If the problem persists it is a good idea to see the local Peugeot expert or locksmith. They'll use a diagnostic tool to assist in identifying the problem and fix it.

The loss of your peugeot 2008 key car keys can be an extremely stressful experience. However, a qualified auto locksmith can solve the issue in a matter of minutes. They can cut a new key and programme it to your vehicle, making sure you're out on the road in the shortest time possible. Click here to locate a locksmith near you.

Electronic chip that is malfunctioning

The chip inside your Peugeot 308 key fob is a very important component of the remote control system. If the chip is damaged, you may experience difficulties starting your vehicle or receive a message saying "anti-theft". In this case, the only solution is to replace the key. Fortunately, auto locksmiths with experience can provide the service within the shortest period of time.

The chip inside your Peugeot 308 key fob can fail due to water damage, sweat dirt, or any other cause. If your peugeot 107 spare key (a cool way to improve) 308 key fob has been exposed to soapy water, cleanse it immediately. You can make use of a towel and isopropyl alcohol for cleaning the electronic component. The battery should be allowed to fully dry.

Sometimes, a key fob can not function due to radio interference. This could be due to other devices operate on the same frequency as your Peugeot keyfob. It can also be caused by weather conditions or objects that are in the vicinity of the vehicle. If you experience this problem, it is best to visit a Peugeot dealership.

The Peugeot 207/308 Key Fob is delicate and needs special care. It is not recommended to drop it or throw it around. If you lose something, try to find it as soon as possible. You can reset the onboard computer by disconnection of the battery for a couple of minutes. Be sure to disconnect the negative first, and then the positive.